Logo

B3754 Engine Code Repair

Meaning of B3754 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B3754 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B3754 code is occuring now you should check B3754 repair processes.
Now don't ask yourself; What should you do with B3754 code ?
The solution is here :

B3754 Possible Solution:

B3754 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

B3754 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

3
Ignition System Or Misfire

7
Fuel Temperature Sensor B Circuit Range/Performance

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

4
Exhaust Gas Recirculation Sensor B Circuit High

Regarding the B3754 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B3754 OBD-II Diagnostic Body (B) Trouble Code Description

B3754 engine trouble code is about Exhaust Gas Recirculation Sensor B Circuit High.

Main reason For B3754 Code

The reason of B3754 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

B3754 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.